MORPHTONE STRINGS [ARCO CLOSE]

To optimize the work with this patch, I advise you to make the following settings for FL Studio:
1) Shrink mesh for less detail (Options->Project->Time Settings->Time base (PRQ) [24] )
2) Set the maximum delay in the properties of your audio card.
3) Run the patch in a separate project without everything and use it for recording.
4) Disable all extraneous background applications.

Strings; Orchestral; Pad; Ambient; Atmosphere;

Compiled with FL Studio 20.9.1.
This patch consumes a lot of CPU resources.

Now a little about the patch itself!

I assembled it for 4 months, relying on the sound of an orchestra with the addition of additional instruments such as choir, organ and vibratone. It is based on the Vital synthesizer. The rest of the plugins are standard plugins of FL Studio itself. Each synthesizer is a separate section of string instruments with different settings and sound character. Responds to keystroke velosity.

Due to the fact that the patch turned out to be large and I couldn’t upload it in its entirety to PresetShare. I had to split it into 3 modules.

1. MORPHTONE STRINGS [ARCO CLOSE]

This module is close stringed instruments. By the nature of the sound reminiscent of the raw sounds of violins and cello.

There are several faders to control:
1. Dynamic (controls the overall volume of the instrument's intro). If you lower it to the very bottom, the sound will be played at low volume.

The remaining parameters are classic synthesizer parameters:
1. Attack (Control of the soft entry of the instrument).
2. Release (Control of the smooth decay of the instrument).
3. Pitch (Tonal control of the smooth introduction of the instrument).
4. Dekey (Pitch Attacks brevity control)
5. Reverb (control of instrument space).
6. Compressor (Controls all of the Vital's built-in compressors.)
7.Master (total output volume).
8. Resampling (1-x2, 2-x4, 3-x8).